Skip to main content
Home  /  Technical Support  /  Driver Updates  /  Fusion Drivers

Fusion/Fusion M2

Firmware & Driver Downloads

Signup to receive email notification when a new driver or firmware is available for your laser model.
Fusion M2 32/40 Tech Specs

Software/Firmware for Fusion and Fusion M2 Laser Systems

Fusion Series PC Driver 1.072 (07/20/2015)

Replaces 1.071
  • Warning! If you have previous DAT files, you will need to use the DAT converter, found below.
  • Default units for Color Mapping changed from cm to mm for computers using the metric system.

DAT Converter (07/08/2015)

Mac Fusion Driver 1.00 Beta (10/13/14)

OS X 10.7 – 10.11, macOS Sierra (10.12)

  • Adds Fusion 40 compatibility.
  • Bug fixes.
  • Beta Version.
  • For additional steps to use the driver on macOS Sierra, please read the instructions below.

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)
  • Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

Firmware: 1.0.2.1 (06/11/2018)

Replaces 1.0.1.8 (11/04/2016) and Beta Firmware 1.0.1.9/1.0.2.0
  • Adds a scaling factor for the 3-Jaw Chuck Rotary
  • Fixes a bug that caused the Rotary to index incorrectly when using Center-Center Engraving