Epilog Mini 18/24 and Helix Firmware and Driver Downloads

Driver Update Notification Signup

Signup to receive email notification when a new driver or firmware is available for your laser model.


Signup Now

Epilog Mini/Helix Driver 9.03 (01/07/15)

Replaces version 9.02 (08/25/14)

  • Warning! If you are using DAT files in your driver you must update them with the DAT converter software below.
  • Fix for vector sorting commands sent to Job Manager.
  • Adds support for the Epilog Job Manager.
  • Optional: Download individual files.
  • Download install instructions.

 

Download Now

DAT Converter (08/15/14)

 

Download Now

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)

  • Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

64 bit

  • Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
  • For more information on the Job Manager, click here.
  • Download install and use instructions.

Download Now

32 bit

  • Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
  • For more information on the Job Manager, click here.
  • Download install and use instructions.

Download Now

Firmware: 1.0.3.0 (03/10/11)

Replaces 1.0.2.9

  • This release fixes an obscure bug in Mini/Helix systems that caused inconsistent engraving on graphics that were raster only images, but run in Combined mode, with Air Assist enabled at the machine.
  • Read install instructions.

Download Now

Download Now (.zip)

Configuration Files



Contact Us

Have a question we can help you with?

Portions of this page translated by Google.